[gecode-users] path constraint with a single node

[Kish Shen]

Hi,

I am doing some tests with the new constraints I have just added to the 
ECLiPSe gecode interface, and the path constraint fails when there is 
only one node -- should this succeed, with the start and end nodes both 
set to 0, and the successor node for node 0 (the only node) set to 1?

(with the circuit constraint with 1 node, the constrain succeeds with 
the successor of node 0 set to 0)

Cheers,

Kish

-- 
This e-mail may contain confidential and privileged material for the
sole use of the intended recipient. Any review, use, distribution or
disclosure by others is strictly prohibited. If you are not the intended
recipient (or authorized to receive for the recipient), please contact
the sender by reply e-mail and delete all copies of this message.
Cisco Systems Limited (Company Number: 02558939), is registered in
England and Wales with its registered office at 1 Callaghan Square,
Cardiff, South Glamorgan CF10 5BT.